BETCO STEALTH ASO20BT, Руководство оператора и каталог запасных частей, Страница: 4 / 27

6 7
1. HANDLING THE PACKED MACHINE
The machine is contained in specific packaging.
It is not possible to place more than two packages on top of each other.
The total weight, as shipped with batteries, is 481 lb. (218 kg).
The overall dimensions of the package are:
A : 45.1 in (1145 mm)
B : 26.2 in (665 mm)
C : 48.4 in (1230 mm)
2. HOW TO UNPACK THE MACHINE
A. Remove the outer packaging.
B. Remove the key (1) from the ignition to prevent damage.
C. The machine is fixed to the pallet with wedges (2) which lock the wheels.
Remove these wedges.
D. Disengage the parking brake (3) by rotating the lever until the brake is no
longer in contact with the wheel.
E. Use a ramp to get the machine down from the pallet, pushing it backwards.
F. Keep the pallet for any future transport needs.
MACHINE PREPARATION
3. BATTERY INSTALLATION
The machine will be supplied with a battery charger and either two 12V Wet or
AGM batteries. The batteries must be housed in the battery tray in the battery
compartment beneath the recovery tank.
To insert the batteries you must:
A. Lower the squeegee and brush deck.
B. Open the rear latch that secures the recovery tank (2).
C. Rotate the recovery tank as far as it will go, using the side handle (3).
WARNING: To avoid acid leakage you can use sealed batteries.
WARNING: Perform one battery charging cycle before using the
machine.
4. TYPE OF BATTERY
To power the machine you can use:
• Wet batteries
• AGM batteries
• Gel batteries
OTHER TYPES MUST NOT BE USED.
The maximum dimensions and the weight are:
Width 6.7 in (171 mm)
Length 12.9 in (329 mm)
Height 9.6 in (245 mm)
Weight 68 lb. (31 kg)
WARNING: Your charger must be set according to the type of bat-
tery you install. Call BETCO customer service to ensure correct
charger setting after replacement batteries are installed.
• The batteries must be handled using lifting and transportation means suitable
for the weight and dimensions.
• They must be lifted by the handles on the upper part.
• They must be connected together in series, to obtain an overall voltage of
24V on the lugs.
• The electrical connection operations must be carried out by certified trained
personnel.
MACHINE PREPARATION