BETCO E29974, Руководство оператора

Страница: 7 / 12

7
USE AND MAINTENANCE TIPS
1. REMOVAL OF BRUSHES AND CLEANING THE MACHINE
After each use, the brushes should be removed and cleaned. The underside of
the machine should be cleaned as well.
A. Disconnect the power supply from the machine.
B. Lay the machine on the floor and pull the axle out from the center of the
brush on the right side of the machine.
C. Clean the brushes with jet-powered water.
D. Clean the underside of the machine with a hand brush or cloth.
E. Grease between the bearing, cover, and the bearing shaft entrance using
white lithium grease.
F. To install the brushes, simply slide the axle back through the center core of
the brush until it locks into place on the left side of the machine.
G. The brushes should be replaced once the overall bristle to bristle diameter is
less than 2.75”.
2. MACHINE LUBRICATION
A. Disconnect the power supply from the machine.
B. Remove the bearing cover monthly and clean using WD40 and then dry
thoroughly using compressed air.
C. Every 3 months, remove the gear cover, clean the gears with WD40, and
regrease the gears with white lithium grease.
D. Reinstall the bearing cover and gear cover before resuming operation.
3. MOTOR SAFETY SWITCH
A. The safety switch automatically cuts off the electricity when the motor
overloads.
B. Should this happen, disconnect the power supply, wait 30 seconds, and
press the button inwards to reset the safety switch.
C. Then reconnect the power supply and continue working.
D. If the safety switch continually trips, cease operation and please contact your
Authorized Betco Distributor or Retailer.
WARNING: Carry out all maintenance operations with the
power cord unplugged from the wall outlet.