BETCO E29974, Руководство оператора

Страница: 4 / 12

4
1. ASSEMBLING THE HANDLE
The handle assembly is comprised of four individual parts.
A. Install the main cross bar onto the machine by pulling the finger pins
outward on both sides and locking them into the handle mounts of the
machine.
B. Insert the open end of both handle uprights into the cross bar.
C. Insert the open end of the round handle bar into each of the handle
uprights.
2. SIDE SHIELDS
Be sure the machine is not plugged in when performing this installation.
A. Place the open end of the teardrop hole over the mounting pins.
B. Slide the side shield to the right until the center spring pin locks it into place.
C. Repeat this installation on the other side of the machine.
3. ASSEMBLING THE STORAGE TRAY
A. Insert the metal support into the two holes on both sides of the plastic
storage tray.
B. Insert the metal axle through the single hole on both sides of the plastic
storage tray.
C. Attach the wheels to each end of the axle. The metal clip on the inside hub
of the wheel should lock into place on the channel at each end of the axle.
MACHINE PREPARATION
A
B
C
A
B
C