Beta Three TQ-18, Справочное руководство

Страница: 21 / 64

UG-TQ18-EN (V2.2-211226) - 13 -
TQ-18
Mixer Reference
manua
2.1.3 Send operation of the channels
In the input channel editing mode, the quick knobs
[Send1] ~ [Send4]
indicators on the panel
are lit, and the four bus buttons are in a group:
[AUX1] ~ [AUX4], [AUX5] ~ [AUX8], [ FX1] ~ [FX4]
are
lit separately, click other buttons that are not lit to switch to this group. The knobs Send1 ~
Send4 correspond to the four buses whose indicators are on. Rotating the knob can adjust the
volume sent by the current input channel to the bus. For example, plan to send channel
CH02
to
the effect processor
FX3
, and then output the effect from
AUX5
. The steps are:
(1). Select the input channel where
CH02
is located , and click the button of
channel
CH02
to enter the edit page.
(2). Click any button of the bus button to switch to the
FX
group as
the sending destination.
(3). Turn
Send3
knob to adjust the volume sent by
CH02
to
FX3
.
(4). Then, select the input channel where
FX3
is located , and click the button
of channel
FX3
to enter the editing page.
(5). Click any button of the bus button to switch to
AUX5 ~ 8
group as
the sending destination.
(6). Turn
Send1
knob to adjust the volume sent by
FX3
to
AUX05
.
In the channel overview interface, the volume sent by the input channel to each output bus
is shown
16
in section 2.1.2. On other pages, use the pop-up window to send the volume, as
shown below: