Beta Max SCAFF-TRAC 6-11, Руководство оператора

Страница: 24 / 39

24 BETA MAX PORTABLE HOIST SYSTEMS
These Strengths Apply Only When A Test Is Conducted With Both Ends Fixed. Avoid
Common Wire Rope Abuses Such As Shock Loading, Over Stressing, Corrosion,
Crushing, Too Sudden Load Release And Lack of Lubrication.
REMOVAL OF WIRE ROPE
Mount the hoist in the proper horizontal llifting position and remove the weight, thimble and hooks
from old rope.
1. Connect hoist to correct power source, operate down button on pendant station until rope is
completely spooled away from the drum.
KEEP FINGERS AWAY FROM DRUM WHEN HOIST IS OPERATING
2. Locate the cavity in the rear of the drum and pull the sleeve end of the rope out far enough to
cut and remove sleeve. The rope will then slip out of the drum.
INSTALLING THE WIRE ROPE
Mount the hoist in the proper horizontal lifting position. Be sure to use the proper rope diameter
and length for your hoist model (see rope size specification table pg. 23). New wire rope must be
terminated with a press fitting on the drum end of the rope (see specifications for terminating wire
rope pg. 25).
1. If new rope is already terminated with press fitting, feed the end through cavity on the motor
end of the drum until firmly seated in cavity.
2. If new rope has not been terminated, feed one end through hole and pull out through the
cavity. terminate the rope in the proper manner. (see instructions on terminating wire rope pg.
25).
3. connect hoist to the correct power source and operate the UP button on the pendant switch.
Guide and layer the rope carefully onto the drum. Keep the rope tight against the drum. Do
not allow the rope to loosely spool onto the drum.
KEEP FINGERS AWAY FROM DRUM WHEN HOIST IS OPERATING.
4. Be sure the free end of the rope is threaded through the emergency up limit stop bar. Re-
source the weight and thimble with press fitting or clamps. (see instructions for terminating
wire rope pg. 25).