7
Each LED indicator represents 2 hours of working time. You can push the Set Working
Hours Button to adjust the desired time.
• After setting the run time, the pump will restart automatically at the same time the following
day.
• In case of a power outage or the GFCI being unplugged, the running time of the product
will be reset to a 10 hour default and the previous set will be deleted.
• After finishing the working time, the GFCI goes into stand-by mode. During this time, all
LED indicators will be off.
• Pushing the test button on the GFCI does not stop the timer. To stop the timer, you have
to unplug the GFCI.
Timer LED Indicator Set Working
Hours Button
2hrs
4hrs
6hrs
8hrs
10hrs
TIMER
CHECK LIST
To check the parts included in the box, consult the part list inside this manual. Verify that the equipment components represent
the model that you had intended to purchase. In case of any damaged or missing parts at the time of purchase, visit our website
bestwayusa.com/support.
CHOOSE THE CORRECT LOCATION
Place the Filter Pump on a solid and level ground; it must be positioned on the same level as the base of the pool. If the
Filter Pump is in an upper or lower position than the base of the pool, the performance and life span of the Filter Pump can
be compromised. The pool and the Filter Pump have to be positioned in an area with adequate drainage and easy access
for maintenance operations. Never place the Filter Pump in a area that may accumulate water.
• For the installation instructions, refer to the illustration steps inside the manual. Drawings are for illustration purposes
only. May not reflect actual product. Not to scale.
• Bestway will not be responsible for any damage caused to the Filter Pump due to mishandling or failure to follow these
instructions.
• It is imperative to check that the hydraulic connectors are not obstructed.
• Do not dry run the Filter Pump. Make sure both the pool's inlet and outlet valves are fully covered by water before operating
the Filter Pump.
SETUP
GFCI TEST
STORAGE
WARRANTY TERMS
MAINTENANCE
INSTALLATION
• Make sure that the Filter Pump is unplugged before any maintenance.
• For the maintenance instructions, refer to illustration steps inside the manual. Drawings are for illustration purposes
only. May not reflect actual product. Not to scale.
• To optimize the Filter Pump performance and for sanitary reasons, we suggest replacing the filter cartridge with a new
one every two weeks.
• Remove all accessories; be sure that Filter Pump, hoses and debris screens are completely clean and dry before the storage.
If all the parts are not completely dry, mold may result.
• Before storage, remove and dispose of the filter cartridge.
• We strongly recommend disassembling the Filter Pump when the environment temperature is below 50ºF / 10ºC.
• Store the Filter Pump in a dry place with a moderate temperature between 50ºF / 10ºC and 100ºF / 38ºC.
For information concerning warranty terms, visit our website at: www.bestwayusa.com
