Bestway 58515, Руководство пользователя

Страница: 12 / 56

12
A. Insert the plug into the power outlet.
B. Press the “RESET” button; the
indicator light turns red.
NOTE: If the indicator light is not on, the
test has failed.
C. Press the “T” button; the indicator light turns off.
NOTE:
If the indicator light is not off, the test has failed.
D. Press the “RESET” button, the indicator light turns red, and the sand filter is ready
for use.
WARNING: RISK OF ELECTRIC SHOCK. The RCD plug must be tested before
each use.
WARNING: Do not use the sand filter if this test fails. Please contact your local
Bestway Aftersales Service.
WARNING: Insert the RCD plug into a residual current device (RCD) having a rated
residual operating current not exceeding 30mA.
D C B A
Air Release
Press down the control valve handle and wait untill the water flow
from Port D to release the air.
NOTE:
It is important to repeat this operation every time you start
the pump after winterizing, maintenance and backwashing the sand
bed.
FIRST TIME USE INSTRUCTIONS
Backwash and Rinsing
must be performed to prepare the pump for
its first use and to wash the sand.
CAUTION: DO NOT DRY RUN THE SAND FILTER
1. Press down on the Control Valve handle and rotate to the Backwash
function.
2. Plug in and run the sand filter for 3-5 minutes,
or until the water runs clear.
3. Switch off the sand filter and set the Control
Valve to the Rinse function.
4. Switch on the sand filter and run the sand filter for 1 min. This
circulates water backwards through the sand filter and drains water out
Port D.
5.
Switch off the sand filter. Set the Control Valve to the Closed function.
6. Top up pool water if required.
IMPORTANT:
This procedure removes water from the pool, which
you’ll need to replace.
Switch off the sand filter immediately if water levels near the pool’s Inlet
and Outlet valves.
Backwash Rinsing
RCD Test