Bestway 56377, Руководство пользователя

Страница: 5 / 108

POOL MAINTENANCE
Warning: If you do not adhere to the maintenance guidelines covered herein, your
health might be at risk, especially that of children. Pool water treatment is essential for
the safety of the users. Using chemicals inappropriately will cause property damage
and personal injury.
NOTE: The pump is used to circulate the water and to filter small particles. In order to
keep your pool water clean and hygienic, you must also add chemicals.
1. It is recommended not to fill the pool with catchment water, drilling water, or
drainage well water: these waters generally contain polluted organic substances
including nitrates and phosphates. Filling pools with water from the public network
is advised.
2. Always keep your pool clean and apply the correct pool chemicals. Unsanitary
water is a serious health hazard. It is recommended to use disinfectant, flocculant,
acid or alkali chemicals to treat your pool.
3. Clean the PVC liner regularly with non-abrasive brushes or a pool vacuum cleaner.
4. Throughout the season, the water filtration system must run long enough each day
to clean the entire volume of water in the pool.
5. Check the filter cartridge (or sand in a sand filter) regularly and replace dirty
cartridges (or sand).
6. Regularly check the screws, bolts and all the metal parts for rust. Replace if necessary.
SELECTING A SUITABLE LOCATION
WARNING: Leveling is extremely important.
Carefully select the location for your new pool. This is the most important
decision you will have to make to ensure the safety and success of your
pool’s construction. A poorly-chosen location could cause problems in the
future that may cause injury, death or financial loss. Read carefully the
checklist below when selecting where to set up your pool.
Acceptable:
Flat, level, firm and dry ground with easy access to all sides of the pool
Exposed to direct sunlight
Access to electricity for running the filter pump and other pool accessories
Easy to access to a water source
Protection from wind
Position the pool near an adequate system to discharge the pool
Unacceptable:
Sloping, uneven ground
Sandy, rocky or soggy ground
Close to wooden construction (e.g. pergolas and decking)
Next to trees
Overhead wires and clotheslines
Drains, electric wires or gas pipelines underneath the site
Poor or little drainage
High flood risk locations
High wind conditions
NOTE: Remove the higher ground rather than filling the low laying ground.
All grass and sod under entire pool area must be removed.
0°
5
Tools Required (not included):
Installation usually takes approximately 1 hour with 2-3 people excluding earthworks
and filling.
PART LIST
7. If it rains, check that the water level is not higher than the specified level.
If water exceeds the specified levels, drain the pool to the specified level.
8. Do not use the pump when the pool is in use.
9. Cover the pool when not in use.
10. For pool water treatment, the pH value is very important.
ATTENTION: Do not leave the drained pool outside.
ATTENTION: Please do not clean or perform any maintenance work on the PVC
liner when the temperature is lower than 5°C (41°F).
The following parameters ensure good quality water
WINTERIZATION
If you do not want to dismantle the pool in winter, please observe the following
instructions:
IMPORTANT:
Do not drain all of the pool water. If you do so, the pool may be
damaged by strong wind. Drain the water to 10cm below the inlet valve on the pool
wall.
1. Drain the water to 10cm below the inlet valve on the pool wall. You can use a
pump or a garden hose (Diagrams 19, 20).
2. Treat the pool water with a suitable chemical product.
3. Remove the filtration system from the pool.
You can leave the inlets/outlets attached to the pool.
4. Also remove any other pool accessories and store them in a dry and cool place.
5. Protect the pool with the pool cover.
If you want to dismantle the pool in winter, please observe the following instructions:
1. Drain the pool with a garden hose, or use a drain pump to empty the pool
(Diagram 19).
2. Clean all pool parts with a sponge and soap with a neutral pH. Dry them and tidy
them away in a dry and clean place.
Qty Spare Part No. Qty Spare Part No. Qty Spare Part No. Qty Spare Part No.
1 Rail Cover PVC 20 P61246 24 P61246 24 P61246 28 P61246
2 M6 Cap Nut Stainless Steel 19 P61247 19 P61247 23 P61247 26 P61247
3 M6x11 Bolt Stainless Steel 19 P6746 19 P6746 23 P6746 26 P6746
4 Control Valve 2 P6(H1)1229 2 P6(H1)1229 2 P6(H1)1229 2 P6(H1)1229
5 Pool Inlet Strainer 1 P6H1317 1 P6H1317 1 P6H1317 1 P6H1317
6 Pool Outlet
Strainer
1 P6H1323 1 P6H1323 1 P6H1323 1 P6H1323
7 Liner PVC 1 56377ASS16 1 56386ASS16 1 56607ASS17 1 56611ASS17
8 Hose Adaptor 2 F6H202 2 F6H202 2 F6H202 2 F6H202
9 3M Self-adhesive
tape
1 P61248 1 P61248 1 P61460 1 P6756
10 Rail PVC 20 P61492 24 P61493 24 P61458 28 P61459
11 Steel Wall Coated Steel 1 P61433 1 P61434 1 P61435 1 P61436
12 Clips Plastic 20 20 20 20
13 Rail Connector Plastic 40 P61422 48 P61422 48 P61422 56 P61422
16’ x 42’’ 18’ x 48’’
NO. Name Material
12’ x 36’’ 15’ x 36’’
S-S-004186