Bestron DT48C, Инструкция по эксплуатации

Страница: 28 / 40

user’s instructions
28
English
First switch off the power in the room you are
working in. Preferably by removing the fuse for
the specific group or switching the group off in
your fuse box. Now check whether the power is
really off!
10. Mount the mounting plate to the ceiling or
to the ceiling outlet. Preferably with 4 solid
screws distributed over the 4 slotted holes in
the mounting plate (See Figure 7).
• Ensure that in all cases the attachment is
strong enough for a weight of 23 kg!
• Make sure the wires, which come from the
ceiling, will be guided through the hole of
the mounting plate.
11. Connect the yellow-green wire, which comes from the ceiling, to the terminal block of the mounting plate.
Use the connection on the right side of the block. That is the side closest to the hole.
12. Connect the blue wire, which comes from the ceiling, to the terminal block of the mounting plate.
Use the connection “N” on the right side of the block. That is the side closest to the hole.
13. Connect the brown wire, which comes from the ceiling, to the terminal block of the mounting plate.
Use the connection “L” on the right side of the block. That is the side closest to the hole.
14. Hang the fan fully assembled with the canopy
to the J-hook under the mounting plate. Now
you have your hands free to install the wiring.
(See Figure 8A)
15. Connect the yellow-green wire (which is
disconnected in point 2) again to the earth
screw and the rest of the yellow-green wire on
the inside of the canopy.
16. Connect the blue wire, which comes from the
motor, to the terminal block of the mounting
plate.
Use the jack “N” on the outside side of the
block. That is the side closest to the edge. (See
figure 8B)
17. Connect the blue wire, which comes from the motor, to the terminal block of the mounting plate.
Use the jack “L” on the outside side of the block. That is the side closest to the edge. (See figure 8B)
18. Cut the black wire, which comes from the motor, as far as possible. This wire should not be used.
19. Remove the fan of the J-hook, and slide the canopy over the two half loosened screws in the mounting
plate.
20. Turn the canopy slightly so the fan can not fall down any more. Then tighten the screws.
21. Now fasten the remaining 2 screws in the canopy.
22. Your fan is now hanging at 4 screws to the mounting plate and can be used.
23. Turn the power back on and check the fan by pulling the cord.
A B
N
L