instruction manual
17
English
• Be sure that the hair is completely dried up before you start styling.
operAtion - use
1. Put the plug into the wall socket and heat it up for about 10 minutes.
When the hairstyler is used in a damp room, such as a bathroom, unplug it directly after use since the
proximity of water presents a hazard even when the appliance is switched off. For additional protection,
the installation of a residual current device (RCD) having a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer for
advice.
Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
3. Turn the on/off switch (3) on:
position 1 - warm
position 2 - hot
position C - cool
operAtion - curling
1. Comb you hair well through.
2. Take a little hair lock and twist it around the brush. (see figure 3)
Figure 3
2. Leave the hair around the brush for a few seconds and release it carefully. Press
the release button (2) and let the brush roll out.
3. Repeat this by every hair lock.
Do not comb the hair until it has completely cooled down.
When you finished styling your hair, you can fixate it with a little bit of hairspray. After you washed your
hair again, the effect will be lost completely.
cleAning And MAintenAnce
1. Pull the plug out of the wall socked and leave the appliance to cool down.
2. Clean the appliance with a moistures cloth and polish it with a dry cloth.
• Make sure the plug has been removed from the wall socket before cleaning the appliance.
• Never use corrosive or scouring cleaning products or sharp objects (such as a knife or a hard
brush) to clean the appliance.
• Never immerse the appliance, the power cord or the plug in water or any other liquid.
guArAntee terMs
The importer guarantees the appliance against defects caused by manufacturing and/or material faults for
60 months from the date of purchase, subject to the following conditions.
