Section 4
Install Power Switch
Page 6
P6 - 54857 - Rev. A 0415
Installation Instructions - Trektop PRO Defrost Harness
© 2015 Bestop, Inc.
Hardware
Step 1
Step 3
Step 2
Remove the power switch from wiring
harness “B”. Make note of the connections
and the wire colors for when you re-connect
the switch later.
Step 1
Fish the harness end with the three leads
up behind the dashboard and through the
1” hole you drilled earlier.
Step 2
Reconnect the power switch to the three
leads. Make sure to connect the wires to
the correct terminals.
Feed the harness back through the
hole until the switch can be seated in
to the hole.
Snap the switch into the 1” hole.
Step 3
Wiring Harness “B”
Power
Switch
POWER LOAD GROUND
Power Switch
POWER LOAD GROUND
Red
Blk
POWER
LOAD
GROUND
Power Switch
Red
