Pet Barrier – Installation Instructions
Rev. F 0114
42502 pg. 3
Place the Lower Partition in the vehicle from the rear.
Use the M6 x 15mm Thumbscrews to secure the
Lower Partition to the Base Brackets installed in
Step 1.
Use a T-40 Torx to remove the screw from the front
corner near the sport bar and discard it. Use an M8
x 35mm Hex Bolt to install a Middle Bracket. Repeat
on both sides of the vehicle.
Use a 13mm wrench and socket to install a Middle
Bracket in the hole near the front sport bar using
an M8 x 35mm Hex Bolt, M8 Bushing, two (2) M8
Washers and an M8 Nut. Repeat on both sides of
the vehicle.
Install Lower Partition
Install Middle Brackets
Install Middle Brackets
Hard Top
Soft Top
Use a 4mm allen wrench and two (2) M6 x 25mm
Button Head Screws with two (2) M6 Spring
Washers to secure the Lower Partition to the
Middle Brackets installed in Step 2.
Use a 10mm socket to remove the front bolt from
the outside of the speaker/sound bar.
Orient the Upper Connecting Bracket so that the
threaded insert on the bracket is toward the outside
of the vehicle.
Reuse the bolt to install the Upper Connecting
Bracket.
Secure Lower Partition to
Middle Brackets
Install Upper Connecting
Brackets
T-40 Torx
Right Middle
Bracket
M8 x 35mm
Hex Bolt
M8 Bushing
M8 Washer
M8 Washer
M8 Nut
Right Middle
Bracket
Middle
Bracket
Passenger Side Shown
Passenger Side Shown
Base
Bracket
M6 x 15mm
Thumbscrew
Lower
Partition
Middle
Bracket
M6 x 25mm Button
Head Screw with
M6 Spring Washer
