UTY 618
8
RESTRICTED
November 1995
$
Figure 2: Single-Phase
UNITY
/I UPS
Section 200: Removing the Batteries
IMPORTANT
The steps in Sections 200 and 300 must be performed in order.
200-1.
Remove the screws at the corners of the front ventilation panel and remove the panel
from the unit. Also, remove the bottom narrow front panel(s). See Figure 2.
NOTE:
On a UT8K, also remove the front kick plate (found below the front
ventilation panel); slide it upward, then pull it away from the unit.
200-2.
Remove the battery tray handle from the back of the unit (see Figure 2). Keep the two
bolts handy to use in step 200-4.
200-3.
At the front of the unit, remove the bolt that secures the battery tray to the floor of
the chassis. To find the bolt, look under the two cables labeled “+” connected
between the bottom DC connector and the fuse board (see “Bolt” in Figure 2).
