Best Power 610 - Optional Features
You may wish to connect your UPS to a network management system using SNMP. This will require the
purchase of the Bestlink SNMP/WEB Adaptor card option (Part No. 0610-SNMP-00), which will install in the
communications slot on the rear of the UPS. This device when, plugged into the UPS communications slot and
connected to the network, can allow a network supervisor to monitor and control the UPS via SNMP protocol
under such popular network management platforms
like HP OpenView, IBM NetView, etc. In addition, the
user may also manage the BestLink UPS through a web
browser such as Netscape or Internet Explorer.
The BestLink SNMP/Web adaptor card has a 10BASE-T
Ethernet interface built in. The SNMP adaptor has a DIP
switch to set the I/P address assignments and two (2)
LED indicators show power or network status plus
error conditions.
In the BestLink SNMP/Web Adaptor card option package
you will find the following items :
•
One - SNMP adaptor card
•
One - 3.5” DOS-formatted diskette containing
the UPS SNMP Agent MIB
•
One - 3.5” tar- formatted diskette containing the UPS SNMP Agent MIB
•
One - User Manual
•
One - Alternate mounting plate
To install the BestLink SNMP/Web adaptor card complete the following :
1.
Shut down your protected load. Press the UPS or
(Standby) switch and remove the input line
cord from the wall socket.
CAUTION : Even with the UPS switched off, dangerous voltages may still be
present at the UPS or its outlets.
2.
Remove the communications slot cover on the rear of the UPS. Slide the BestLink SNMP/Web adaptor
card option into the slot and secure it with supplied screws.
3.
Store the communications slot cover plate for recovery in case the BestLink SNMP/Web adaptor card
option is removed and decommissioned in the future.
4.
Follow the detailed set-up instructions found in the “User Manual” that came with the BestLink SNMP/
WEB Adaptor Card option package.
5.3 BestLink SNMP/WEB Card Installation and Operation
11
- Optional Features
