1.
Locate (2) two 48" long 2x4s.
2.
Install (3) three 2x4-74-1/2" wall studs between
the boards. Install third stud in the center of the
wall frame.
1.
Locate the 48" wide pre-assembled end wall panel that has an angled corner on the left when
face of siding is up.
2.
Install the wall frame assembled above next to this wall. Nail the frame to the end wall with
10d sinkers.
1.
Locate 22" wide partially assembled front wall panel with angled corner and a 43-3/4" long
2x4.
2.
Cut the 2x4 board to a length of 21" and nail to bottom of studs of the wall panel. The left end
will be flush edge of short stud. The right end will extend beyond long stud by 1-1/2" to receive
header support. Siding will extend 3/4" below 2x4 plate. Use 10d sinkers. See below.
Step 8
Assemble 4' Wide Back Wall Center Frame
48" Wall Plate
Step 9
Attach Center Back Wall to End Wall
LAP
Edge
3.
Install a 48" wide siding panel
over the center wall frame.
Step 10 Assemble Front Wall Frames
69-1/2" long 2x4
Header Support
3.
Install a 69-1/2" long 2x4 to the side of the wall frame
nailing to long stud and 21" 2x4. Use 10d sinkers.
4.
Cut the siding flush with the edge of the 2x4 header
support.
21" long 2x4 Plate
Pre-assembled End Wall
5.
Using 8d galv. nails finish nailing
panel to studs.