48" x 72"
48" x 48"
48" x 83-1/2"
36-1/2" x 83-1/2"
Panel Extends
7-1/2" Beyond
Gable
36-1/2" x 72"
3.
Butt (2) two 1x4-4' fascia boards to the 6' board. See sheathing drawing below. Repeat to
install (2) two more 1x4-4' fascia boards on the opposite side.
4.
Cut (2) two 48" x 85-3/4" panels from the extension kit. See detail below,
5.
Install roof sheathing per layout below. Starting at rear of building install a 48"x48" OSB
roof panel flush with face of 1x4 gable trim. Plumb each truss and gable. Make sure the
sheets meet at center of truss. Use 6d common nails spaced 12" apart. The top row of roof
sheathing will be about 1" below the ridge to allow for optional ventilation. Important: Make
sure the roof sheathing extends 7-1/2" past the siding on the face of the gable.
1x4-6'
1x4-4'
36-1/2" x 48"
Step 17 Install 1x4 Fascia & Roof Sheathing
1x4 -6' Fascia Board
1x4 Fascia
2x4 Truss
Roof Sheathing
Straight Edge
2x4 Tie Plate
2x4 Soffit Block
Nail Fascia to
2x4 Block
1.
Starting at the rear of the building, install a 1x4-6' fascia board against the rear gable trim.
Install the fascia so the bottom edge of the roof sheathing will rest on the edge of the 1x4. See
Detail 'E'. Use a straight edge to align the 1x4 board with the top of the trusses.Use 6d galv.
nails.
2.
Repeat on opposite side wall.
Detail 'E'
48" x 48"
36-1/2" x 48"
Cut each 48" x 85-3/4" panel from the extension kit
to a 48" x 48" and a 36-1/2" x 48" long panel.
"
48" x 48"
48" x
36-1/2"
"
"
"
"
1x4-4'
