22
ASSEMBLY OF THE MACHINE
Installation of engine
1. Attach the clutch case to the engine with the 4 Allen
screws (in tool bag).
2. Remove cable adjuster and nut from carburettor
adjuster bracket and replace with the cable adjuster
fitted to the brushcutter throttle cable.
The procedure may be easier if the air filter cover is
removed.
3. Slide inner throttle cable into carburettor throttle arm.
4. Adjust the play of the throttle wire as detailed below.
5. Connect ignition wires.
ref. Honda GX35
In essence the procedure is the same as listed above with
the exception of the method of fixing the brushcutter
cable adjuster.
1. Remove air filter cover.
2. Separate the adjuster locknuts 5mm
3. Insert inner cable into carburettor throttle arm.
4. Place cable adjuster between engine cowl adjuster
holding forks and finger tighten nuts and adjust the
play of the throttle wire to between 0.5mm - 1.0mm.
and lock nuts.
NOTE:
Excessive play will cause starting failure.
5. Connect ignition wires and replace air filter cover.
Adjusting the throttle wire
Using the throttle cable adjuster nut, adjust the play of
the throttle wire to between 0.5mm - 1.0mm and lock
nuts.
NOTE:
Excessive play will cause a starting failure.
If your machine differs from that shown, please refer to
the engine manufacturer’s instructions.
Locking
nut
Adjusting nut
Содержание PaiceSetter PSX280W
