3
.3.
After connection, date and time on gas detector will synchronize automatically with computer.
"Real-time"
is for collecting real-time data, these data will only store on computer, check&analyze these
data on "Data show" section "Real-time d
a
ta".
"History data"
is for checking data collected by gas detector or data have been stored on computer
A. Real-time data collection and checking
Real-time
m
Every
-
minutes once
Modify
1.
Click "Modify" to set inte1val time from
1-10
min, click "Save"to confum.
2. Switch "Real-time" ON, you'll get real-time data and they will be shown on "Show Data" chart.
3. Stop real-time d
a
ta collection by switching OFF.
Show data
Real-time data
D
Hist01ydata
0
li2S
l"J
02
l"J
CO
l"J
C}{4
BST MG06001 00
B. Gas detector data collection and checking
2014·07•03
V
2014•07 •03
V
1. Click "Get data" to get data collected by device, time needed is 1-6 minutes, device will show
"Loading" during this period.
2. Check&analyze these dat
a
on "Data show" section "Histo1y data".
3. This softwai·e can get and store data from several gas detectors, when data acquisition finished for one
device, click "Disconnect" and connect with another one.
4. Click "Clear data" to delete all data collected by gas detector
5. When collecting data by device, user has 2 operation methods
a. Set device following "Gas detector data collection setting"
b. Set "Device setting" on softwai·e
iifii::1
·
•
�
14
MW
■
,
·
l1l
■
hiiiilll�11111J
1
)Set valid sta1t and stop time, click "Modify" to set time inte1val from
1-10lll,
then click "Save" to
finish.
2)User will find � on top of detecting inte1face, which means device is collecting& st01ing data.
3)Accident power ON or OFF dUiing strut and stop time will not affect data collection, after restarting,
data collection will go on .
3.4.
"Show data"
section
Tick the colorful boxes to choose gases needed to be shown up on chart.
"Real-time data" is for real-time collected data.
