LOGGER SETTING
BASIC:(Pic.3)
1:ID setting
Maximum 20 characters , name your logger press OK button
to confirm.
2:Current Date/Time
Clock setting, the system automatically shows current date
and time of your PC. Press OK to confirm.
(Note :Schedule date & time refer to current pc date and
time)
►Click OK to sync the meter ’s date and time every time.
3 LCD display set
:
(N/A for non-LCD models)
Press ON ( Logger LCD still illuminated after complete
recording ), or OFF( LCD is not illuminated after complete
recording. Press OK after selection.
ALARM&SENSOR:(Pic.4)
1.Select Temp./Humidity alarm, set Hi/Lo Temp. and
Hi/Lo Humidity values.
(Red LED will flash if the current reading is over the setting.)
2.Select the parameter you want to record.
Example: Total is 32K memory, if choose Temp. and RH
sensors at the same time, memory store will split to 16K for
Temp.+16K for RH.
(Pic.4)
(Pic.3)
P4
SETTING:(Pic.5)
1 Set sample point (K=1,000 multiple basis within total
:
memory points)
2.Set sample rate, start mode to record:
Select “hour(1~6), “minute(0~59)”,“second(0~59)” time interval.
Select 5 start to record modes from: (See more detail below)
(a) Immediate
(b) Schedule
(c)Real-time (PC is always connected with the logger unit)
(d) Key start (Start recording by pressing button)
(e) Roll-over (when memory are full, logger covers the
earliest memory automatically)
(Pic.5)
