7
Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied)
to the left side if required.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Make sure that the plug is removed
from the mains socket.
Additional parts (in the plastic bag)
Allen Wrench(4mm)
Left Hinge
Left Hinge Cover
Right Screw Cover
Left Middle Hinge
Left Stop Block*2
Left Door Stopper*2
Note:
If required, the refrigerator may be
positioned on its back in order to gain
access to the base, it should be rested on
soft foam packaging or similar material to
avoid damaging the backboard of the
refrigerator. To reverse the door, the
following steps are recommended.
1. Stand the refrigerator upright. Open the
door to
remove
all door racks (to avoid
damage) and then close the door.
Caution!
slightly squeeze the door rack from two
sides towards the center and inside of the
door rack, then move it upward when
taking out the upper rack and lower rack.
2. Remove right upper hinge cover
①
on
top of the cabinet. Remove the 3 screws
②
used for fixing the right upper hinge part
(see picture below) and dismount the
upper hinge parts
③
.
