Follow-Up instrpection apply to products with
14
5. After connecting the water supply, water
filter,
and
the
refrigerator,
water
connecting system layout shows below.
Note:
It is recommended to employ a qualified
person to install the water system.
If you have to repair or disassemble the
water line, cut off the ends of water line
(1/4") to make sure you get a snug,
leak-free connection.
Warning!
After turning on the shutoff valve, make
sure that there is no leakage at all
connection points of the water lines.
If there is a leakage, turn off the shutoff
valve immediately and tighten the
connector or make the water lines fully
inserted into the connector.
After powering on the refrigerator, let the
ice maker make ice for one to two days,
then throw out the first one or two buckets
of ice to make sure that all impurities have
been removed from the water lines.
Do not pull hard on the water lines, it may
damage the water system.
The water line should not be pressed by
heavy things and should not bend too
much.
.
filters and without filters
1/4”tube(assembled)
4. Connect the
with
refrigerator by a connector.
1) Fully insert the other head of the
into the connector.
2) Fully insert the water line of the
refrigerator (at the right of the compressor
room) into the connector.
3) Insert two clips in the install pack as
shown below, and then confirm that each
clip holds the water line firmly.
1/4”tube(assembled)
1/4”tube(assembled)
If you choose to use without the water filter.
