Bertazzoni PRM604GEVSXT, Инструкция по установке, обслуживанию и эксплуатации

Страница: 5 / 52

5
REPLACING COMPONENTS
Before carrying out any maintenance, unplug the appliance from the gas and electricity mains.
To replace components such as knobs and burner heads, simply remove from their housing without disassembling
any part of the cooker.
To replace components such as burner holders, taps and electrical components, proceed as described in the
section on adjusting burners. If replacing the gas tap or thermostat, the two rear ramp brackets need to be
disassembled by removing the 4 screws (2 screws per bracket), which secure it to the rest of the cooker; remove
the 2 screws securing the bracket of the taps to the control panel support, after removing the knobs. If the gas or
electric thermostat is to be replaced, the rear cooker protection also needs to be removed. Remove the screws, to
take out and put back the thermostat bulb.
To replace the oven light, unscrew the light cover inside the oven (Figure 16).
NOTE: Before replacing the light, unplug the appliance from the mains.
NOTE: If replacing the power supply lead, the installer should keep the earthing wire longer than
the live wires and follow instructions for electrical connections.
USE AND MAINTENANCE MANUAL
DESCRIPTION OF HOB PARTS
Size of gas burners Table 3
BURNER
SIZE (mm)
1 Auxiliary ∅
50
2 Semirapid ∅
70
3 Rapid
−{}−∅ 95
4 Triple ring
∅
130
CONTROL PANEL
On the control panel, a symbol is displayed for each knob or switch, to indicate the function, as described below:
The symbols , o , show the position of the burners on the
hob and the square/circle shows the burner in question (in this case the front left burner)
The symbol or shows the oven is being used (gas oven electric grill – change-
over switch with 9 settings)
the symbol or indicates the electric thermostat for electric fan ovens