EN
www.universal.bertazzoni.com
www.universal.bertazzoni.com
15
5.1 Built-in installation of single
appliance
For a built-in installation, to close gaps between the
appliance and the adjacent cabinets, special side pro-
files (installed) and aluminum trim covers (taped to
back of appliance) are provided. Side profiles are used
for fixing the appliance to the niche cabinet and can
be shimmed from the side of the appliance in order to
match the niche width. (Remove screws holding trim to
side of appliance and place washers between profile
and appliance and replace screws for example).
Operate as follows:
>
Push the appliance into the installation niche
[ 1 ]
.
>
If the unit is to be installed inside a niche or within
an enclosed structure, it is not necessary to design a
ventilation shaft at the back of the niche as European
models come with a top ventilation cap which accom-
modates sufficient ventilation even though it is behind
the overlay panel.
Ensure panels are mounted (BI Series) prior to pushing
the appliance all the way into the niche as the panel
mounting procedure requires additional height clea-
rance than the niche provides. If for some reason the
top ventilation cap has been removed - a minimum
5mm gap must be provided at the top / back of the ca-
binetry to allow warm air to escape.
5. INSTALLATION
Once the front panel has been adjusted, check
that the gasket has been repositioned correctly
to assure the door/drawer are closing cor-
rectly and avoid operational errors of the unit.
>
Check the levelling of the appliance, adjusting its feet
and wheels to correct it.
>
Using the screws provided, secure the appliance to
the adjacent cabinets through the holes on the profile
side trims
[ 2 ]
.
To make this operation easier keep the door and the
drawer open. It may be necessary to hold the door at an
approximate 70 degree angle to get the easiest access
on the hinge side profile with a screwdriver.
>
Install the profile trim covers: mate with the face of
the appliance and the top of the niche then slide late-
rally over the profile trims. It will be necessary to press
firmly or use a block and mallet to completely lock the
trims into place until a ‘click’ is heard. Take care not to
damage the soft aluminum trims. Ensure that the full
installation is satisfactory prior to installing the profile
trim covers as it is very difficult to remove them wi-
thout damaging them after installation
[ 3 ]
.
B
A
6,5 (
¼”
)
6,5 (
¼”
)
20
(
¾”
)
20
(
¾”
)
22
(
7⁄8”
)
22
(
7⁄8”
)
22 (
7⁄8”
)
22 (
7⁄8”
)
Appliance
Wall
or
furniture
Wall
or
furniture
SIDE PROFILES MOUNTING
A Connecting element
B Alluminium frame
1
2
3
Содержание 75 Series
Страница 142: ......
Страница 143: ......
Страница 144: ...www universal bertazzoni com numero verde 800 927 987 ...