Bernina deco 330, Инструкция по эксплуатации, обслуживанию и список запчастей

Страница: 19 / 31

17
Deco 330
Replacing Threader Plate and Adjustment
If the hook on the threader plate is damaged, replace it asfollows.
1
2
3
View-X
(X)
Fig. 1
Fig. 2
Fig. 3
3
1
2
4
5
2
1
4
3
5
To replace:
1 Pry out the Threader plate holder 1 with screwdriver
while pushing and holding the Threader knob 4 (See
fig.1.).
2 Align the groove on the new Threader plate holder 1
with the Pin 2 on the threader shaft. Push the
Threader plate holder 1 up until it snaps in place.
Threader plate holder
Pin
Hook
Threader knob
Adjustment procedure:
1. If the threader hook thrusts or hits against either left
or right edge of the needle eye: Loosen Screw (A) 1
and adjust the position of the Threader plate 2 .
(See fig. 2).
2. If the threader hook thrusts against either top or
bottom edge of the needle eye, or misses the needle
eye:
Remove the face cover and loosen Screw (B) 3 .
Move the Threader position adjusting holder 4 up or
down to adjust the hook position.
Screw (A)
Threader plate
Screw (B)
Threader position adjusting holder
Needle bar
4
2
1
3
4