BERNHARDT design a.k.a. C-base, Инструкция по эксплуатации, Страница: 5 / 20

September 2012
Step 11
To install the next Workwall Structure section, simply lift
into place and slip the yellow alignment pins into
corresponding rail of the previous mounted section. Make
sure that the seam between the two sections is tight
without gaps.
Repeat Steps 7-11 for the remaining Workwall Structure
sections.
Step 12
After all Workwall Structure sections have been mounted,
they then must be shimmed to be made flat and true
across all of the mounted panels.
Step 13
Place a level or long straight edge along the front surface
of each of the Workwall rails to show the dips or
protruding areas.
Warning: If the panel assembly is not flat and free of any
dips or bulges there may be issues in securing panels or
hanging components properly.
Step 14
The
¼ ”– 20 bolts use to attached the Workwall sections
can be loosened and a shim can be added between the
wall and the Workwall section to bring out any low spots.