EXPRESS DUAL 3000MC
© Bernhard and Company Limited
16
6. In-frame Grinding
(Continued)
6.4.4
Moving the flexible Shaft
There is a layshaft socket at both ends of the
machine into which the flexible drive can be
engaged as required. The other end of the
flexible shaft can be disconnected if required
but this would not generally be necessary as
the bracket and shaft would normally be moved
as an assembly.
The flexible drive shaft can be detached
from its socket on the end of the machine by
pulling sharply on the shaft, to release it from
a spring loaded ball detent. (Earlier units by
first removing the spring retainer (R-pin)), and
withdrawing the complete shaft. When replacing
the shaft, ensure that it is properly engaged
in the layshaft socket (and if appropriate, the
spring retainer securely replaced).
By loosening the socket screw and allowing
the clamp nut, under the table, to twist through
approximately 90 degrees, the whole assembly
can be lifted clear of the table, and moved to the
other side of the mower unit if required.
Содержание EXPRESS DUAL 3000MC
