4
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
4. Charging the battery pack
IMPORTANT: Before use, ensure the battery is charged.
The battery pack as a power indicator, press the button on the pack to see the current state of charge.
To charge the battery remove it from the pressure washer (for best results charge at room
temperature). Charging must be done indoors.
Connect the battery pack to the charger supplied as shown below. Connect the charge to mains
power. The LED indicator will show the following:
Flickering
Battery Charging
Full Steady Light
Charging Complete
No indicator light
Charging fault
Please ensure the battery is disconnected from the charger once charging is complete and charger is
unplugged from the mains power.
NOTE:
1.
The lithium battery pack supplied is not fully charged. It is recommended the battery be fully charged before
first use.
2.
Please ensure charging is carried out in a ventilated and dry environment. The complete charging process
takes about 1 to 5 hours.
3.
During use, when the machine automatically switches from high to low pressure mode this indicates that the
battery power has insufficient and requires charging.
4.
When the power is too low, the machine will automatically power-off to protect the battery. Please charge
immediately. Battery should not be left flat is can cause permanent damage to the battery.
OPERATING INSTRUCTIONS
Please follow the above instructions to assemble and configure the pressure washer ready for use. Once
assembled, ensure the water inlet hose is submerged in water and the extension pipe and or accessories are
correctly fitted and secure.
To operate; point at the ground and squeeze the handle trigger to start the pressure washer. Release the
trigger to stop.
