BERG KOMPBERG ZX75, Руководство по эксплуатации и техническому обслуживанию

Страница: 11 / 30

4.2. Requirements concerning electrical system
-
The compressors are designed to be supplied by a four-conductor 400 V AC, 50 Hz power line.
-
The compressors are equipped with PE terminal.
No. Compressor type
Power lead cross
sectional area
mm
2
Fuse size
NH gL/gG, 500V, 100kA
D gL/gG, 500V, 50kA
1
KOMPBERG ZX75
PE 160
-
The power cable cross sectional area should be matched to the current drawn by the
compressor.
-
The compressors can only be operated on three-phase earthed system (TN).
-
The compressor must be supplied from the distribution board equipped with a slow blow fuse
and circuit-breaker that enables the compressor power supply to be completely disconnected.
-
Electrical connection of the compressor should be performed in accordance with the attached
electrical diagram.
-
Only authorised personnel or qualified electrician is allowed to perform electrical connections.
-
Use the required safety measures in accordance with the suitable regulations.
-
Calculate the power cable cross sectional area and fuse sizes according to the local regulations
and operating conditions.
-
Below there are presented the recommended power cable cross sectional areas and fuse sizes
for standard compressors.
-
A user takes a full responsibility for selection of an electrical system and power supply connection
for the compressor.
Recommended power cable cross sectional area and fuse sizes
4.3. Compressed air connection
It is recommended to use galvanized steel or plastic tubes for the compressed air
system.
When the compressed air treatment equipment (filters, dryer) is installed, the existing
compressed air piping should be replaced with a new one, unless air supplied
previously wastreated by similar equipment.
Each BERG compressor should be connected to the compressed air network by using a
flexible conduit or flexible connector (axial expansion joint) and shut-off valve.
Compressed air
outlet
Pneumatic
hose
Elbow