Bercomac BERCO 701011-1, Руководство пользователя

Страница: 7 / 20

Assembly & initial set-up
5
C. Remove the 1/4 "nylon insert lock nuts (item a)
and 5/16" flat washers (item a) that were
preinstalled on the snowblower. Leave the 1/4
"x 3/4" carriage bolts in place.
D. Install the assembled hydraulic motor (item 6)
on the snowblower using the four 1/4 "x 3/4"
carriage bolts already in place, four flat washers
(item a), previously removed, and four nylon
insert lock nuts 1/4 '' (item a), previously
removed. Tighten in place.
Adjustment of the hydraulic motor
A. Adjust the hydraulic motor (item 1) by loosening
the three nuts on the carriage bolts (item 2) that
hold the hydraulic motor in place. Do not remove
the nuts.
B. Slide the motor towards the chute (item 3) as
shown (the grooves on the motor’s sprocket
must match those of the rotation ring). Adjust
and retighten the nuts (item 2). Tighten firmly.
C. Install the sprocket guard (item 4) as illustrated
and secure in place with the hardware removed
previously: two 1/4 '' x 3/4 '' bolts (item 5), two
lock washers (item 6) and two flat washers (item
7).
Installation of the hoses support
A. If necessary, remove one or the two bolts and
nuts already in place (item a) depending on the
location of the support.
B. Install the hose support (item 1) using the 1/2 "x
1 3/4" bolts (item 2) and the 1/2 "nylon insert
lock nuts (item 3).
NOTE: Install in an appropriate location making sure
the hose support does not come into contact with the
vehicle when the accessory is in all possible positions
(accessory completely lifted, accessory completely
lowered). And any sharp edge on the tractor or
accessories.
C. Install the support extension if necessary (item
1), as illustrated. Use the 5/16 ’x 1’’ bolts (item 2)
and the 5/16’’ nylon insert lock nuts (item 3).
NOTE: Install in an appropriate location making sure
the support extension does not come into contact with
the vehicle when the accessory is lifted.
Install without tightening, the attaching plates