Berco 700360- 700360-2, Руководство пользователя

Страница: 15 / 29

13
BELT REPLACEMENT:
For belt part numbers, refer to snowblower parts
breakdown section for parts identification
Snowblower must be detached & disconnected
from the A.T.V. to replace belts
V-Belt:
a) Remove the belt guard (item 1)
b) Remove the 7/16 x 5 1/2’’ hex bolt (item 2) from
the clutch support.
c) Disconnect the wire from electric clutch.
d) Remove the gas tank from the support. (Put on
the ground to avoid any spills).
e) Turn the snowblower face down (engine on top).
f) Remove the six nuts (item 3) and bolts from the
reduction plate (item 4).
g) Remove the reduction plate.
h) Unhook the spring (item 5) from the slot on the
tension arm (item 6) and remove the tension arm.
i) Replace the V-belt.
j) Re-install parts by repeating steps backwards.
(Make sure the pin on the reduction plate is
inserted in the tube on the tension arm).
BELT REPLACEMENT & ADJUSTMENTS
CAUTION
Never use the snowblower without the belt guard.
Timing Belt:
a) Remove the gas tank from the support. (Put on
the ground to avoid any spills).
b) Turn the snowblower face down (engine on top).
c) Loosen the two nuts (item 7) on each side and
the two nuts (item 8) needed to apply tension to
the belt.
d) Remove the six nuts (item 3) and bolts from the
reduction plate (item 4)
e) Remove the reduction plate
f) Unhook the spring (item 5) from the slot on the
tension arm (item 6) and remove the tension arm.
g) Replace the timing belt. (Make sure to replace the
V-belt on the V-pulley).
h) Re-install parts by repeating steps backwards.
(Make sure the pin on the reduction plate is
inserted in the tube on the tension arm).
IMPORTANT:
Make sure the notches of the belt are well
inserted into the those of the pulley.
TIMING BELT ADJUSTMENT:
To obtain the right tension on the timing belt, make
sure that the four nuts (item 7) are loosened. Tighten
the two nuts (item 8) needed to apply tension to the
belt until the three spring washers (item 9) are
completely compressed. Tighten the four nuts (item
7).
NOTE: To help avoid the belt from breaking, it is
preferable to put less tension on the belt than too
much tension.
Before re-installing snowblower to ATV, turn the
auger by hand a few turns and verify that the timing
belt does not run off to the side of the sprocket the
belt does move, re-align by adjusting the nuts (item 7
and / or item 3).
After installing the snowblower to ATV, let
snowblower run for a minute, turn everything off and
re-inspect the belt. If needed re-align by adjusting
nuts.