![background image](http://html1.mh-extra.com/html/berco/700360-700360-2/700360-700360-2_owners-manual_2736476013.webp)
11
OPERATING THE SNOWBLOWER
You must be sitting on the saddle in order to
start the snowblower engine.
a) Make sure the snowblower is clear of snow
before engaging the snowblower.
b) Make sure that the auger and fan operate freely.
c) Start the snowblower engine.
d) Before engaging the snowblower drive, always
have the engine running at medium R.P.M.
e) Operate the snowblower at maximum engine
R.P.M.
IMPORTANT: USE FULL ENGINE R.P.M. WHEN
REMOVING WET, STICKY SNOW. LOW R.P.M.
POWER WILL TEND TO PLUG THE CHUTE.
ELECTRIC CONTROLS
See page 10 for identification of the saddle
controls.
RAISING AND LOWERING THE SNOWBLOWER:
Use the winch switch control to raise and lower the
snowblower.
TURNING THE CHUTE AND DEFLECTOR:
Use the switches on the saddle to turn the chute and
to raise or lower the deflector.
ENGAGING
AND
DISENGAGING
THE
SNOWBLOWER:
Engage the snowblower when the engine is running
at medium R.P.M. by pulling the P.T.O. switch.
OPERATION
REMOVING SNOW
When removing snow, do not use the snowblower as
a dozer blade to push snow. Allow snowblower to
ingest snow at its own speed. If the speed of your
A.T.V. is too fast, the snowblower may become
overloaded and plug. For best results, raise the
snowblower and remove a top layer of snow. A
second pass with the snowblower will remove the
remaining snow.
WARNING
Read the A.T.V.’s owner’s manual carefully. Be
thoroughly familiar with the controls & proper
use of the attachment. Know how to stop the unit
& disengage the controls quickly
.
WARNING
-Do not attempt to clear plugged chute, auger or
fan of snow while the snowblower's engine is
running.
-Disengage snowblower.
-Lower snowblower onto ground.
-Set the parking brake.
-Stop engine, remove the ignition key, disconnect
the wire from spark plug(s) and keep away from
spark plug(s) to prevent accidental starting.
-Make sure all moving parts have stopped.
-Do not use hand to unplug chute.
-Use a 36’’ (924 mm.) minimum length stick or
board.
WARNING
TO PREVENT INJURIES AND FOR MORE
TRACTION WHEN USING SNOWBLOWER:
-Do not drive faster than 3 km/hr (2 m/hr) with
snowblower on the ground.
-Do not drive faster than 10 km/hr (6 m/hr) with
the snowblower in raised position.
-Do not operate on a slope greater than 10°.
-
A.T.V. manufacturer approved tire chains are
required.
Содержание 700360- 700360-2
Страница 18: ...16 PARTS BREAKDOWN NOMENCLATURE DES PIÈCES ROTATION SYSTEM WITH CHUTE SYSTÈME DE ROTATION AVEC GOULOTTE ...
Страница 20: ...18 PARTS BREAKDOWN NOMENCLATURE DES PIÈCES SADDLE ASSEMBLY SELLE ASSEMBLÉE ...
Страница 22: ...20 PARTS BREAKDOWN NOMENCLATURE DES PIÈCES SNOWBLOWER SOUFFLEUSE ...
Страница 26: ...24 PARTS BREAKDOWN NOMENCLATURE DES PIÈCES SUBFRAME SOUS CHÂSSIS ...