Berbel Firstline Unseen BEH 60 FLU, Инструкции по эксплуатации и установке для моделей

Страница: 26 / 36

26
Operation
6003295_g – 19.03.2019
Button Function
The device is turned off.
☞
Press button 1x.
The device switches on with power level 1.
The device is turned off.
☞
Press button for 2 seconds.
The device switches on with power
level POWER.
The device is switched on.
☞
Press button 1x.
The device changes up one power level.
The device is switched on with power level 2
or 3.
☞
Press button 1x.
The device changes down one power level.
The device is switched on with power level 2
or 3.
☞
Press button for 2 seconds.
The device switches off or the automatic run-
after function starts.
The device is switched on with power level 1.
☞
Press button 1x.
The device switches off or the automatic run-
after function starts.
The active power level is displayed by the LEDs illuminated
beneath the buttons:
y
1 LED lights up = Power level 1
y
2 LEDs light up = Power level 2
y
3 LEDs light up = Power level 3
y
3 LEDs light up in sequence = Power level POWER
4.2.1 Normal operation
D WARNING
Fire hazard due to grease residue!
In operation grease residue, which is highly inflammable,
collects in and on the device.
☞
Clean the device properly.
D
“5. Cleaning” (page 28).
To achieve an optimal efficiency in removing cooking fumes:
☞
Turn the device on 1-2 minutes before you start cooking.
This allows the flow of air to build up, and the fumes are
removed at an early stage.
☞
In order to collect the cooking fumes effectively, use the
rear hob plates for intensive cooking.
☞
During the cooking process, switch to a power level that
is appropriate for the intensity of the cooking vapours:
y Power level 1 - lowest fan power
y Power level 2 - medium fan power
y Power level 3 - high fan power
☞
If the intensity of the cooking vapours does not subside,
switch to a higher power level.
☞
Switch to the power level POWER when searing. After
6 minutes, the device automatically switches back to
power level 3.
To activate the power level POWER permanently,
the corresponding button must be pushed again.
Then the device doesn’t switch back.
☞
Check the fresh air supply at regular intervals.
☞
Use the device also to reduce other unpleasant smells.
Such as from:
y Onions and garlic
y Oven, microwave and steamer
y Fondue and raclette
☞
Turn on the run-on function when you have finished
cooking.
☞
After use, turn the device off. When the run-on function
is activated, the run-on time (10 minutes) automatically
starts in power level 1.
After switching off, LED 2 glows every 30 operating hours to
remind about cleaning the Capillar Trap.
If LED 2 flashes:
☞
Clean the Capillar Trap.
☞
Follow the cleaning instructions.
D
“5. Cleaning” (page 28).
☞
Press the run-on function button to end the flashing
display.
After 6 hours without operation, the device (including
lighting) automatically switches off.