14
E N G L I S H
Mains plug replacement
(U.K. & Ireland only)
•
Should your mains plug need replacing and you are
competent to do this, proceed as instructed below. If
you are in doubt, contact an authorized Berner repair
agent or a quali
fi
ed electrician.
•
Disconnect the plug from the supply.
•
Cut off the plug and dispose of it safely; a plug with
bared copper conductors is dangerous if engaged in
a live socket outlet.
• Only
fi
t 13 Amperes BS1363A approved plugs
fi
tted
with the correctly rated fuse (1).
•
The cable wire colours, or a letter, will be marked
at the connection points of most good quality plugs.
Attach the wires to their respective points in the plug
(see below). Brown is for Live (L) (2) and Blue is for
Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the outer
sheath of the cable
fi
rmly and that the two leads are
correctly
fi
xed at the terminal screws. Never use
a light socket.
Never use a light socket.
Never connect the live (L) or neutral (N) wires
to the earth pin marked E or .
For 115 V units with a power rating exceeding 1500 W, we
recommend to
fi
t a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this machine
(see technical data). The minimum conductor size is
1.5 mm². The cable has to have a rubber jacket and a
grounding conductor. When using a cable reel, always
unwind the cable completely.
Also refer to the table below.
Conductor size (mm
2
) Cable rating (Amperes)
0.75
6
1.00
10
1.50
15
2.50
20
4.00
25
Cable length (m)
7.5 15 25 30 45 60
Voltage Amperes
Cable rating (Amperes)
230
0
-
2.0 6 6 6 6 6 6
2.1
-
3.4 6 6 6 6 6 6
3.5
-
5.0 6 6 6 6 10 15
5.1
-
7.0 10 10 10 10 15 15
7.1
-
12.0 15 15 15 15 20 20
12.1
-
20.0 20 20 20 20 25 -
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Mounting the saw blade (
fi
g. B)
• Move the blade clamp lever (2) up to release the
blade clamping mechanism.
• Insert the saw blade into the holder (4) until it
engages. The blade can be installed with the teeth
pointing down or up, or left or right.
•
Move the blade clamp lever (2) down to lock the blade
clamping mechanism.
•
To remove the saw blade, proceed in reverse order.
Saw blades
material
recommended saw blade
ferrous metal
fi
ne-toothed
non ferrous metal
coarse-toothed
wood coarse-toothed
plastic
fi
ne-toothed
masonry carbide-tipped
A wide variety of dedicated saw blades is available as
an option.
Always select your saw blade with great care.
Instructions for use
•
Always observe the safety instructions and
applicable regulations.
•
Ensure the material to be sawn is secured
in place.
• Apply only a gentle pressure to the tool
and do not exert side pressure on the
saw blade. If possible, work with the saw
shoe pressed against the workpiece. This
