Electric Espresso Coffee Maker Use instructions
EN
13
Coffee brewing starts automatically when the clock on the display is at “07:00”, the “timer on” indicator goes off,
in the meantime the “on / off” indicator lights up. When it is 07:30, the coffee maker turns off and the lights go out.
Keep warm function
With the keep warm function can be drunk hot coffee at the right temperature for more than half an hour after
switching on the machine.
This function is automatically activated each time the unit will be switched on.
Cleaning and maintenance
Before performing the cleaning operations after use, wait for the machine to cool down.
Clean the inside of the dispenser periodically.
Regularly check the funnel and the gasket. Replace if there are signs of wear or deterioration. Use only original
spare parts.
Occasionally check that the filter holes are not blocked, if necessary, clean with a pin (Fig. C, point 8).
Do not wash the coffee machine in the dishwasher.
Do not use solvents or abrasive detergents to clean the boiler. It is sufficient to clean it with a sponge, keeping
attention not to wet the electrical parts.
When removing the disc filter for cleaning or to replace the gasket, remember to reinsert it correctly to avoid
dangerous splashes of hot water.
Do not rinse the boiler under the water tap and do not immerse in water. (Fig. D)
Battery
Under the base of the coffee maker there is a battery compartment, in which it is possible to insert a 3V CR2032
button battery (not included).
The battery is used to keep the settings set once the plug is removed from the socket. The timer continues to
operate, even if no writing appears on the display.
Example: if at this moment the display shows 8.00 and I remove the plug for an hour, when I put the plug in the
socket the display will automatically show 9.00.
To replace the battery, follow the instructions below (Fig. E):
Insert a screwdriver into the battery cover and turn anticlockwise to open the compartment.
Remove the exhausted battery and insert the new battery paying attention to respect the polarity.
Replace the battery cover and tighten it tightly to close it.
Technical data
Power: 400 W
Power supply: 220-240V ~ 50/60Hz
Use battery CR2032, 3V (not included)
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
Содержание BC.041N
Страница 2: ...2 Fig B Fig C Fig D Fig E 1 4 5 6 2 3 ...
