Electric Espresso Coffee Maker Use instructions
12
Important: do not use the coffee maker without water in the boiler and moreover do not use hot water
for faster operation.
3) Insert the funnel filter in the boiler.
4) To prepare one cup of coffee, also insert the adapter in the funnel filter.
5) Fill the funnel filter with ground coffee, without pressing it . Fill it a little at a time to prevent spilling the ground
coffee. Distribute the ground coffee uniformly and remove any excess coffee from the edge of the filter.
Important: use good quality, medium-ground coffee, for moka coffee makers. Do not use barley
coffee.
6) Tighten the coffee maker securely , without exaggerating, holding the boiler with one hand and turning the
pitcher clockwise with the other, without pushing on the handle.
7) Close the lid and place the coffee maker on the base.
8) Every so often check that the holes in the disk filter are not blocked; if necessary, clean it by using a pin.
Manual ignition
Press the “on/off” button. The on/off light indicates that the coffee maker is working, while the “key lock” light
indicates that the key lock function is active.
The coffee will start to come out after a few minutes.
Brewing will be completed in 4-5 minutes. The coffee maker will automatically turn off after the “on / off” light has
been on for 30 minutes.
Programmed self-ignition
This function allows you to program the self-start time of the appliance, for example in the evening for the fol-
lowing morning. Operate as follows:
Set the exact time
Press and hold the “time” button to set the exact time. (Each short press will advance the time by one minute,
hold down to advance the time quickly).
Set the switch-on time
Press the “timer” button, and keep it pressed until the desired switch-on time is reached.
At any time it is possible to view the programmed time by pressing the “timer” button, after a few seconds the
current time reappears on the display.
Once the coffee maker has been prepared and the desired ignition time has been programmed, press the “timer
on” button; the programmed power-on light and the “key lock” light come on.
At the programmed time, the programmed on light will go out and the “on/off” light and the “key lock” light will
come on to signal that the appliance starts to heat the water.
Brewing will be completed in 4-5 minutes. The coffee maker will turn off after the “on/off” light has been on for
30 minutes.
if you want to turn off the “key lock” function, just hold the key in question for 3 seconds; now you can turn off
the coffee maker.
At the end of the brewing
When the brewing is complete, stir the coffee before serving.
Note: the time will start again from scratch when it reaches 24:00, which means that the timer can run
for up to 24 hours.
Memory function: if 7.00 is set as a time for coffee preparation, at 7.00 every morning the coffee will be
prepared, without resetting it every day (unless the user does not change it).
Practical example
Let’s say it’s 9:00 pm. if you want to drink coffee at 07:00 am the following morning, simply set the timer pro-
grammed as follows:
Connect the coffee maker to the electrical outlet.
Press and hold “time” to set the time to 21:00.
Hold “timer” to set the time for 07:00.
Press the “timer on” button to activate the timer.
Содержание BC.041N
Страница 2: ...2 Fig B Fig C Fig D Fig E 1 4 5 6 2 3 ...
