Beper 50.923, Инструкции по применению

Страница: 12 / 32

12
Vacuum Cleaner Use instructions
Removing & cleaning pre-motor filter, centric Hepa filter, and air outlet filter
Warning:
Always unplug the unit from electrical outlet before getting out the dust barrel.
a. Pre-motor filter
1. Press the knob on the dust cup arm.
2. Lift dust barrel up.
3. Take out the pre-motor filter for cleaning and changing.
b. Dual cyclone filter
1. Press the knob on the dust cup arm.
2. Lift dust barrel up.
3. Grasp the body of the dust canister and rotate the lid anti-clockwise then pull apart
4. take apart the dual cyclone system.
5. wash.
c. Air outlet filter (fig. 7)
1. Press the air outlet grid knob to open
2. Take out the air outlet filter for clean and change.
Please note:
The sponge filter material in the cleaner will became dusty over time. This is normal and will not af-
fect the performance of the filter. If the sponge filter is so dusty that suction does not return to 100%,
then we suggest that the filter be removed then rinsed under the faucet and allowed to dry for 24
hours by airing not near the fire or some high temperature objects before refitting into the vacuum.
This should be done once six months or when suction appears to be reduced obviously.
Important:
Please note that there is a safety switch inside the vacuum to prevent the unit from being run with
high vacuum rate. If the vacuum is too high ,the safety switch will be turned on. In this case, it can
minish the vacuum rate and protect the motor from being broken.
Note:
The suction hole must be open, free of any obstructions at all times. Otherwise, the motor will
overheat and could become damaged.
Important:
All filters should be checked regularly for signs of damage, preferably after each cleaning task. The
filters must be replaced immediately if they become damaged. Always disconnect the vacuum from
the electrical outlet when checking the filters.