PAGE No 11
6
TO REPLACE THE THERMOSTAT, NEONS AND
ON/OFF SWITCH
FOLLOW STEPS FOR REMOVING CONTROL
BOX
6:1 TO REMOVE THE THERMOSTAT, REMOVE
THE CONTROL KNOB, AND UNSCREW THE 2
RETAINING SCREWS. REPLACE WITH A NEW
UNIT, AND REFIT ALL ITEMS (FIG. 18).
6:2 TO REMOVE AND REPLACE A NEON.
UNSCREW YTHE LEADS AT THE CONNECTOR
BLOCK (THEY ARE FLYING LEADS), NOTING
THEIR TERMINAL NUMBERS.
UNSCREW THE RETAINING NUT, WITHDRAW
THE NEON, AND REPLACE.
6:3 TO REPLACE THE ON/OFF SWITCH.
UNPLUG ALL WIRES FROM THE SWITCH,
NOTING THEIR TERMINAL NUMBERS, UNCLIP
THE SWITCH, AND FIT A REPLACEMENT.
REFIT ALL WIRES, AND OTHER COMPONENTS.
7
TO REPLACE THE POWER INPUT SOCKET
FOLLOW STEPS FOR REMOVING CONTROL
BOX
7:1 TO REMOVE THE POWER INPUT SOCKET,
NSCREW THE 3 POWER RING TERMINALS/
WIRES FROM THE SOCKET, AND THEN
UNSCREW THE 4 NUTS HOLDING THE
SOCKET IN PLACE (FIG. 19).
REPLACE WITH A NEW ITEM, REFIT
REVERSING THE REMOVAL PROCEDURE.
SERVICE MANUAL
5
TO REPLACE THE CONTROL BOX
FOLLOW STEPS FOR REMOVING THE
INJECTOR
5:1 TAKE OFF THE 2 ALLEN SCREWS HOLDING
THE CONTROL BOX ASSY TO THE BASE (FIG.
17)
5:2 REMOVE THE SINGLE SCREW RETAINING
THE CONTROL BOX TO THE BASE
MOULDING
5:3 REPLACE CONTROL BOX AND RE-ASSEMBLE
ALL COMPONENTS
2 ALLEN
SCREWS
RETAINING
CONTROL
BOX ASSY TO
BASE
SINGLE SCREW
RETAINING
CONTROL BOX
TO BASE
MOULDING
FIG. 17
FIG. 18
FIG. 19
