1403BSHH_AMEN,page 3/29
Unauthorised modification of this appliance or departure
from use in the manner, for which it was intended by the
manufacturer or installed in a manner contrary to these
instructions, may constitute a hazard and jeopardize all
warranties.
Deviations should only be carried out after formal
consent has been obtained from the manufacturer.
Ensure the environment in which the air heater will be
installed will not create a hazard i.e. where excessive
(volatile) dust, flammable or corrosive substances and/or
vapours and combustible materials may be present.
This appliance has been tested and set according to the
data plate before leaving the factory.
1.2
Warranty
Warranty is void if :
a.
Heaters are used in atmospheres containing
flammable vapours or atmospheres containing
chlorinated or halogenated hydrocarbons or any
contaminant (silicone, aluminium oxide, etc…)
that adheres to the spark ignition flame sensing
probe.
b. Wiring is not in accordance with the diagram
furnished with the heater.
c. Unit is installed without proper clearance to
combustible materials or without proper
ventilation and air for combustion.
d.
Air throughput is not adjusted within the range
specified on the rating plate.
MOVING and UNCRATING
This unit was test operated and inspected at the factory
prior to packaging and was in proper operating condition.
Before leaving the factory, the unit is completely
assembled. If the heater has incurred damage in
shipment, document the damage with the transport
company and contact your supplier.
Read this booklet and become familiar with the
installation requirements of your unit. If you do not have
knowledge of local requirements, check with the gas
supplier and any other local agencies that might have
requirements concerning this installation.
Before beginning, make preparations for necessary
supplies, tools and manpower.
IMPORTANT
If the installation includes optional vertical louvers or
downturn nozzle etc., install these options before the
heater is suspended. Follow the instructions included in
the option package.
When transporting the appliance after it has been
unpacked (i.e. fork lifting, etc) note the restrictions and
recommendation indicated in figure 1.
The base frame contains internal support member, which
acts as a lifting fulcrum point to prevent damage to the
underside of the appliance by lifting forks.
Figure 1: Appliance Handling Criteria
Minimum fork length requirement : min. 2/3 of unit length
Minimum fork width for balance
2
WRONG
WRONG
