18
Waking up the transmitter and the receiver
5. Aim the source device’s remote control at the receiver and press buttons to see if the device
could be controlled. If not, the IR blaster frequency needs to be set and synced again. Follow
Step 4 and 5 until the source device’s remote control could work.
Waking up the transmitter and the receiver
• If in standby mode (both power indicators of the transmitter and the receiver are lit in red), press
the power button of either the transmitter or the receiver to turn on both the transmitter and the
receiver. The same condition applies to remote control operation.
• If the transmitter’s HDMI out display is on (transmitter’s power indicator is lit in blue) and the
receiver stays in standby mode (receiver’s power indicator is lit in red), press the power button of
either the receiver or the transmitter to wake up the other and make wireless connection
automatically between each other.
The IR sensor supports remote’s signal protocol of NEC, RC5, and RC6 between 36 KHz ~ 56 KHz. Therefore, it
is possible that some devices may not be supported.
Содержание WDP02
Страница 1: ...WDP02 Wireless FHD Kit User Manual...