Operation
17
Operation
Starting up the projector
1.
Plug the power cord into the projector and into a
power outlet. Turn on the power outlet switch
(where fitted). Check that the
POWER indicator
light
on the projector lights orange after power
has been applied.
Please use the original accessories (e.g. power cord) only with the
device to avoid possible dangers such as electric shock and fire.
2.
Press
POWER
to start the projector. As soon as the lamp lights up, a "
Power
On Ring Tone
" will be heard. The
POWER indicator light
flashes green and
stays green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
To turn off the ring tone, see
"Turning off the Power On/Off Ring Tone" on page 32
for details.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds
before energizing the lamp.
3.
If the projector is activated for the first
time, select your OSD language following
the on-screen instructions.
4.
If you are prompted for a password, press
the arrow keys to enter a six-digit
password. See
"Utilizing the password
function" on page 21
for details.
5.
Switch all of the connected equipment on.
6.
The projector will start to search for input
signals. The current input signal being
scanned appears in the upper left corner of
the screen. If the projector doesn't detect
a valid signal, the message “No Signal” will
continue displaying until an input signal is
found.
You can also press
SOURCE
on the
projector or remote control to select your
desired input signal. See
"Switching input
signal" on page 23
for details.
•
If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the
message “Out of Range”
displayed on the background screen. Please change to an input signal which is
compatible with the projector's resolution or set the input signal to a lower setting. See
"Timing chart" on
page 55
for details.
•
If no signal is detected for 3 minutes, the projector automatically enters ECO BLANK mode.
Downloaded From projector-manual.com BenQ Manuals
