25
Operation
Switching input signal
The projector can be connected to multiple devices at the same time.
However, it can only display one full screen at a time. When starting up,
the projector automatically searches for the available signals.
Be sure the
Advanced Menu - System Setup : Basic
>
Auto Source
menu is
On
if you want the projector to automatically search for the
signals.
To select the source:
1. Press
SOURCE
. A source selection bar appears.
2. Press
/
until your desired signal is selected and press
OK
.
Once detected, the selected source information will appear at the corner of the screen for seconds.
If there is multiple equipment connected to the projector, repeat steps 1-2 to search for another
signal.
• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector’s native
resolution. Any other resolutions will be scaled by the projector depending upon the “aspect ratio” setting,
which may cause some image distortion or loss of picture clarity. See
Aspect Ratio on page 34
.
HDMI1
HDMI2/MHL
PC
Source
