Operation
36
4.
If the action is successful, you see the message '
Captured Succeeded
' on the
screen. The captured picture is saved as
MyScreen
.
5.
To view the captured picture displayed as the startup screen, set
MyScreen
in the
SYSTEM SETUP: Basic
>
Splash Screen
menu and restart the projector.
• Using the OSD menu
1.
Press
MENU/EXIT
and then press / until the
SYSTEM SETUP: Basic
menu
is highlighted.
2.
Press
to
highlight
MyScreen
and press
MODE/ENTER
.
3.
Repeat steps 2-5 in the
"Using the remote control"
section to capture and view the
captured picture.
In the unlikely event that the capturing action fails, change your target picture.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speakers. Be
sure you have made a correct connection to the projector audio input. See
"Connection"
on page 17
for how the audio input is connected.
Muting the sound
To temporarily turn off the sound:
1.
Press
MENU/EXIT
and then press / until the
SYSTEM SETUP: Advanced
menu is highlighted.
2.
Press
to
highlight
Audio Settings
and press
MODE/ENTER
. The
Audio
Settings
page is displayed.
3.
Highlight
Mute
and press / to select
On
.
If available, you can also press
MUTE
on the remote control to toggle projector audio between on and off.
Adjusting the sound level
To adjust the sound level, press
/
VOLUME-
on the remote control, or:
1.
Repeat steps 1-2 above.
2.
Press
to
highlight
Volume
and press / to select a desired sound level.
Adjusting the microphone volume
To adjust the microphone sound level, press
MIC/VOL
keys (+/-) on the remote control,
or:
1.
Repeat steps 1-2 above.
2.
Press
to
highlight
Microphone Volume
and press / to select a desired
sound level.
Turning off the
Power On/Off Ring Tone
To turn off the ring tone:
1.
Repeat steps 1-2 above.
2.
Press
to
highlight
Power On/Off Ring Tone
and press / to select
Off
.
The only way to change
Power On/Off Ring Tone
is setting On or Off here. Setting the sound mute or
changing the sound level will not affect the
Power On/Off Ring Tone
.
