97
Troubleshooting
Eng
lish
- Check the timer settings. Refer to "Setting up timer recording" on page 70.
• A locked disc was inserted:
- Remove disc lock. Refer to "Preventing unintended erasure of a DVD+RW Disc" on page
84.
• A finalized DVD+R has been inserted:
- Change disc.
No audio signal at the digital output:
• The correct audio input on the decoding device may not be selected:
- Check whether the appropriate audio input on the connected decoding device is selected.
• In accordance with SDMI (Secure Digital Music Initiative), the digital audio output is turned
off during MP3 playback.
- Check whether you have inserted an MP3 CD.
A DVD+RW type disc cannot be played on other DVD players:
If a recording is too short, it is possible that a standard DVD player will not be able to detect it.
Please observe the following ’Minimum recording times’ when recording DVDs:
Some DVD players cannot playback DVD+RW recordings.
How to reset DVD recorder settings to factory default?
To reset all DVD recorder settings to its original factory default, follow the steps below:
1 Unplug the power cord from the power outlet.
2 Press and hold the
Power
button on DVD recorder front panel.
3 While holding the
Power
button down, re-plug the power cord into the power outlet. The
message "WAITING" will display on the front display panel.
4 Release the
Power
button.
Now you are ready to perform initial setup for the DVD recorder. For more information, refer
to "Initial startup (virgin mode)" on page 30.
Recording mode
Minimum recording time (minute)
HQ
5 min.
SP
10 min.
LP
15 min.
EP
20 min.
SLP
30 min.
