Benning Tebevert III, Руководство по эксплуатации и обслуживанию

Страница: 37 / 70

TEBEVERT III INVERTER SYSTEM (120 VDC)
07.11.2011 29 028-0009-006
4.1 INVERTER SETTINGS
Each inverter is set to factory default values according to the required
operating conditions. (See Chapter 3.7 / Technical data or the specification
sheet) An adjustment of these settings is not usually necessary.
However, if the inverter must operate at 50 HZ, a simple adjustment can
be carried out.
Warning!
Alteration of the unit settings may only be carried out by
qualified personnel. The altered settings must be clearly
marked on the unit. Any alternations of these settings
must also be performed on all other inverters within the
system and on the SBS.
The output frequency is changed with the DIP switch S2 located on the
rear side of the inverter unit (See Figure 8)
NOTE: Only the setting of switch 1 is changed. All the other switches must
always remain in the OFF position.
50Hz
60Hz
ON
OFF
2 4 3 1