2. Safety note
The instrument is built and tested in accordance with
DIN VDE 0411 part 1/ EN 61010-1
DIN VDE 0411-2-032/ EN 61010-2-032
and has left the factory in perfectly safe technical state.
To maintain this state and ensure safe operation of the appliance tester, the user
must observe the notes and warnings given in these instructions at all times.
The unit may be used only in power circuits within the overvoltage
category III with a conductor for 600 V max. to earth .
Remember that work on electrical components of all kinds is
dangerous. Even low voltages of 30 V AC and 60 V DC may be
dangerous to human life.
Before starting the appliance tester up, always check it as well
as all cables and wires for signs of damage.
Should it appear that safe operation of the appliance tester is no longer possible,
it should be shut down immediately and secured to prevent it being switched
on accidentally.
It may be assumed that safe operation is no longer possible:
- if the instrument or the measuring cables show visible signs of damage, or
- if the appliance tester no longer functions, or
- after long periods of storage under unfavourable conditions, or
- after being subjected to rough transport.
In order to avoid danger,
- do not touch the bare prod tips of the measuring cables
connectors,
- insert the measurement lines in the appropriately
designated measuring sockets on the multimeter
3. Scope of delivery
The scope of delivery for the BENNING CC 2 comprises:
3.1 One BENNING CC 2 with a firmly connected safety measuring line with
90° offset 4 mm safety connector,
3.2 One operating instructions manual
4. Description of appliance tester
The clamp-on adapter BENNING CC 2 is a measuring adapter for analog and
digital multimeters and is used for alternating current measurements up to
200 A.
See figure 1:
Appliance front face
Moreover, the BENNING CC 2 current clamp adapter combined with the
BENNING IT 120 installation tester is appropriate for measuring load currents
from 0.5 A to 20 A.
The display and operator control elements specified in Fig. 1 are designated
as follows:
Measuring pliers
, for clamping on the single wire alternating current
conductor.
Current probe bulge
, protects against contact with conductor.
Opening lever
, for opening and closing the measuring pliers.
Housing with label area
Safety measuring line
with 4 mm safety connector, red, black, 90° offset.
5. General information
5.1 General details on the clamp-on adapter
Sensor type: Induction coil for measuring alternating current
5.1.1 Temperature coefficient of the measured value:
0.2 x (stated measuring precision)/ °C < 18 °C or > 28 °C, related to the
value for the reference temperature of 23° C.
5.1.2 Largest opening of pliers: 21 mm,
5.1.3 Maximum conductor diameter: 20 mm,
5.1.4 Appliance dimensions:
(L x W x H) = 135 x 50 x 30 mm
Appliance weight:
180 g
03/ 2007
BENNING CC 2
6
