background image

BENNETT WARRANTY

SLT7     r052417

Bennett SLT actuators in the United States carry a Limited Lifetime Warranty 

against manufacturing defects. Limited Lifetime Warranty refers to the life of the 

product, not the boat, or the owner. Limited Lifetime Warranty ends when the 

product becomes unusable for reasons other than manufacturing defects.

PLEASE NOTE: Damage to the trim tabs due to electrolysis is not covered by 

warranty. No labor costs of replacement, haulout, or miscellaneous charges are 

covered. Contacting Bennett Marine first may save considerable time, trouble and 

expense. 

The foregoing is in lieu of any and all other warranties, expressed or implied, 

including any warranty of merchantability or fitness for a particular purpose. 

There are no other warranties which extend beyond that set forth above. 

Warranty Return Procedure:

 We recommend that you contact us first to  

troubleshoot your system and determine the best solution. We take great pride 

in providing the best client service. Simply call 954.427.1400 or send an email to 

[email protected]. We will be glad to assist you. 

U.S. Customers: 

Simply return the faulty part to Bennett Marine along with our  

Quick and Easy Product Return Form found on the Warranty page of our 

website: www.BennettTrimTabs.com/warranty. Parts covered under warranty will 

be repaired or replaced without charge. 

Customers Outside the USA:

 Please contact your local Bennett Marine  

distributor for warranty and return procedures in your respective country. 

550 Jim Moran Blvd • Deerfield Beach, FL 

33442 USA

Ph: 954.427.1400 • Fax: 954.480.2897

www.BennettTrimTabs.com 

Содержание SLT6









Отзывы: