Standard RIB Installation
Standard “V”Hull Installation
4
Getting Started - Important Please Read
1. Checking for Obstructions.
Before starting the installation — and drilling
any holes — verify that there are no mounting restrictions inside or outside the
transom. Choose a location about 3-4" from the chine (side of the hull). Hold
the tab up to the very bottom of the transom (flush with hull bottom), and hold
the actuator on the trim tab, using the center set of holes for your starting point.
Then set the actuator upper hinge against the transom. Verify this for both sides
so that the actuators will not center on any obstruction. If they do, reposition tabs
slightly inboard or outboard.
Now you are ready to continue the installation, with Steps 2-12 starting on
the next page.
SLT Installation Instructions
(At leas
t 8" fr
om
cent
erline of driv
e)
8"
(At least 8" fr
om
centerline of driv
e)
8"
Chine
3"- 4"
• Hand drill with 5/32"
and 3/16" drill bits
• Tape measure
• Phillips screwdriver
• Marine grade sealant
• Straight edge
• Marking pencil
• Glove
Tools & Supplies Needed:
