HD-SDI High Speed Dome Camera
7
Picture 8
1). Draw a circle on ceiling
Take the paper pattern(accessory) as a template to draw a pattern on the ceiling. The paper pattern’s diameter is 225mm.
Picture 9
2). Connect Cables:
⑴
connect power cable
、
RS485 control cable
Warning
：
Turn off power supply before connecting cable
⑵
Connect Video output cable
3). Install Upper Cover:
⑴
Adjust the height of the three mounting clips, swing the three mounting clips to cling them to housing.
⑵
Push housing into ceiling and let the clips stretch out. Finally, screw the three clips to tighten the housing.
Note: Use even strength to adjust the three clips, or it may distort the shape of the housing.
（
Picture 1 0
）
Picture 10
4). Install all-in-one Camera:
⑴
Pi
ck up camera from carton to check it, then refer to “appendix VI” to set camera baud rate, protocol and address.
Note
：
If there is something wrong with camera in the process of using, please pack it well, then send it to supplier for repair.
⑵
Unscrew 2 bolts in the picture 1
，
put the screw into hole of key and screw it tightly, then connect IDE26 plug to relevant plug on the
PCB board of camera.
（
refer to 11
）
