Benelli NOVA SPEED, Руководство пользователя

Страница: 27 / 48

21
EN
Shooting with the shotgun
Before carrying out any type of inter -
vention on the shotgun, always make
sure that the chamber, carrier and
magazine are completely empty! (Care-
fully read the instructions for loading and
unloading the shotgun).
Warning: Observe all safety practices
at the beginning of this manual.
1.
Move the safety button to the “fire”
position .
2. Place your finger on the trigger and pull
it back to fire the gun.
3. The bolt will unlock automatically af-
ter firing.
4.
Moving the fore-end fully back will
ex-
tract and eject the fired round and re-
lease a new round
from the magazine
onto the carrier.
5. Moving the fore-end fully forward will
chamber the next round for firing.
6. The trigger must be released and al-
lowed to re-set before the next round
can be fired.
7. Pulling the trigger will fire the cham -
bered round, and the cycle can be re-
peated until all rounds loaded in the
shotgun have been fired.
8. After firing: put the safety in the “ON”
(safe) position, open the bolt by slid-
ing the fore-end all the way back; visu-
ally and physically check the cham -
ber, carrier and magazine to be sure
the firearm is completely unloaded .
Cartridge replacement
(Perform this operation with the gun
safety catch “on”- see “Shotgun safe -
ty” - and the barrel pointing in a safe
direction)
The round in the chamber may be manu-
ally replaced with a different round from
the magazine or another round.
Regarding the selected firearm operation,
it is possible to proceed as follows:
1. Open
the
bolt
, moving back the fore-
end; the chambered cartridge is ex-
tracted and ejected from the firearm,
while the first cartridge in the magazine
automatically drops onto the carrier.
2. Move the bolt back to the closed posi-
tion using the fore-end lever; while it
closes, the bolt chambers the cartridge
on the carrier and stops in a closed po-
sition.
▀
Replacement with a cartridge not
from the magazine
1. Push the carrier inside the shotgun and
at the same time, open the bolt by pull-
ing the fore-end lever. The cartridge in
the chamber is ejected by the extractor
but no cartridge is fed from the maga-
zine.
2. Insert the new cartridge, even partially,
into the chamber through the ejection
port and close the bolt by pushing the
fore-end lever forward. When closing,
the bolt chambers the partially inserted
cartridge and comes to a stop in the
closed position.