BendPak SP-7XE, Инструкция по установке и эксплуатации, Страница: 51 / 68

SP-7XE/F Full-Rise Scissor Lift
51
P/N 5900010 — Rev. B — June 2022
Optional Lift Arm Kit
If you purchased the optional Lift Arm Kit, this section describes how to use it.
The Kit comes with four Lift Arms. To use the Lift Arms, you hook them on the outside edge of a
Platform, put on the desired Pads, drive the Vehicle over the Lift, and then position the Pads under the
manufacturer’s recommended Lifting Points for the Vehicle you are raising.
⚠
DANGER The maximum Vehicle weight you can raise using all four Lift Arms (which must
always be used four at a time) is 4,800 lb. / 2,177 kg. Do
not
raise a Vehicle that
weighs more than this; if you do, you could damage the Lift or the Vehicle, you put
at risk everyone near the Lift, and you void your warranty. Each Lift Arm is rated for
a
maximum
of 1,200 lb. / 544 kg;
never exceed this weight
on one Lift Arm.
You position the Pads by sliding the Lift Arms along the outside edge of the Platform.
Each Lift Arm can be fitted with either a Short Pad or a Tall Pad/Adapter/Base combination, all of
which come with the Lift Arm Kit.
Important
: If you are going to be raising Vehicles with body-on-frame
construction (compared to
unibody construction), BendPak recommends purchasing 35 mm Frame Cradle Pads
for safer lifting. These are available on the BendPak website in the Car Lift
Accessories section . Make sure to order the 35 mm Pin Diameter option.
If you get the Frame Cradle Pads, they replace the Tall Pad in the Tall Pad/Adapter/Base combination.
To switch between Short Pads and the Tall Pad/Adapter/Base, remove the Lock Screw on the end of
the Lift Arm, remove the current Pad, slide on the desired Pad, and then replace the Lock Screw.
If you are using the Tall Pad/Adapter/Base combination, you can use it with or without the Adapter.